Gleason 726 REVACYCLE Vertical Gear Hobbing Machine
| Type | Horizontal |
| Max spindle speed | 1800 rpm |
| Max gear width | 28 mm |
| Motor power | 7.45712 kW |
| Gleason 726 REVACYCLE Vertical Gear Hobbing Machine | |
| Weight | 9000 kg |
Characteristics of the GLEASON 726 REVACYCLE milling machine for bevel gears
– minimum foot angle: 15 °
– maximum foot angle: 55 °
– maximum tooth height: 14.8 mm
– maximum width of the toothed rim measured at the foot line: 28 mm
– division range: 8-50 mm
– cone depth: 15.8 mm
– cone taper per foot: 15.4 mm
– bore with a cone: 57.2 x 77.9 mm
– diameter of the tapered bore at the large end: 99 mm
– hole diameter along the spindle: 22.3 mm
– knife head speed range: 32.6-49.7 m / min
– feeds (seconds per tooth): 2-3.1
– main drive motor power: 10 HP
– main drive engine revolutions (60 Hz / 50 Hz): 1800/1500 rpm
– hydraulic system motor revolutions (60 Hz / 50 Hz): 1800/1500 rpm
– coolant pump speed (60 Hz / 50 Hz): 3600/3000 rpm
– rotation of the chip removal motor (60 Hz / 50 Hz): 1800/1500 rpm
– floor space requirement (L x W): 320 x 221 cm
– the total weight of the machine 726 REVACYCLE: approx. 9 t
GLEASON 726 REVACYCLE straight-tooth milling machine built in the United States, produces the teeth of the bevel gears at a speed of 49.7 m / min, used in differentials. The radial heads of the machine mill the detail with the relative movement of the wheel in relation to the cutter head during roughing. The reliable GLEASON 726 REVACYCLE milling machine for bevel gears guarantees the most accurate and precise machining of details. The total weight of the GLEASON NO 726 is approximately 9,000 kg.
