Gleason NO. 645 Hypoid Gear Generator – Year 1980
Below are catalog spec’s. (To be verified by inspection)
Outer Core: 14.22″ , 14.05″ , 14.88″
Spiral Angle: 29.75″, 30 Deg, 35 Deg.
Cutter Diameter: 12″, 16″ , 18″
Extreme Ratio: 10:1
Root Angle Range: -8Deg. to 90Deg.
Maximum Radial Setting: 10.50″
Coarsest Pitch: 1.5 DP
Full Depth: 1.25″
Face Width Max.: 4.60″
Index Range: 5-80 Inclusive
Work Spindle :: Diameter of Taperhole at Large End 6″
Taper/Ft: 3/4″
Taper/Depth: 6″
Diameter of Hole thru Spindle: 5″
Cutter Diameter: 9″, 12″, 16″, 18″
Work Head Setting: Offset Above Center 4 1/2″
Offset Below Center: 4 1/2″
Machine Center to Nose of Spindle: 23.5″
Speed/Feeds: Cutter 19-167RPM
Electrics: 460 Volts AC Motor and Controls
Weight: 55,000 Lbs.
Equipped With:
Feeds Infinite Variable from 7 Second Per Tooth
Coolant
Hydraulics
Chip Auger
Gleason Hypoid Gear Generator
Model 645
New 1979 – 1980
This machine was just removed from service. The hoses, pipes / plumbing and electric’s on the coolant tank and chip conveyor were disconnected. They were “bagged and tagged” In other words, they were labeled so that they can be put back together without the guess work.
Includes misc. change gears
Includes manuals and schematics
Wired for 440 volts, 3 phase
The machine weight is approx. 58,000 lbs. A rigger is required to load
Machine is sold as is where is as inspected
