GLEASON 650 Hypoid Spiral Bevel Gear Generating Machine – 1978 Model
NEW IN 1978
SUITABLE FOR THE CUTTING OF LARGER SPIRAL BEVEL, HYPOID,
AND ZEROL BEVEL PINIONS AND MATING GEARS UP TO
34” (863.6MM) DIAMETER, 5” (127MM) FACE, WITH
1.08 DP (MODULE 23.5) CUTTING CAPABILITY
EQUIPMENT / FEATURES:
VARIABLE CUTTER SPEED ARRANGEMENT INCLUDING SET OF SPEED
CHANGE GEARS
ASSORTED RATIO-OF-ROLL, MODIFIED ROLL, AND INDEX CHANGE GEARS
W/TOOL & GEAR CABINET
HYDRAULIC CHUCKING ATTACHMENT WITH DRAW-ROD & NUT
AUGER-TYPE CHIP CONVEYOR AND MAGNETIC CHIP SEPARATOR
CUTTER GUARD AND MANIFOLD FOR HIGH VELOCITY COOLANT
SECURITY COVER FOR SET-UP PANEL
STANDARD WORK SPINDLE BORE 6” X ¾” TAPER (#60)
MODIFIED ROLL MECHANISM, INCLUDING CHANGE GEARS FOR ONE PART
ROLL CENTERING
SLIDING BASE SET-IN MECHANISM, INCLUDING CONTROLS
CRADLE ROTATIONAL SET-OVER, INCLUDING CONTROLS
NO ROLL ARRANGEMENT FOR FORMATE AND/OR “DUAL-ROTATION” MACHINE
OPTIONS, INCLUDING CONTROLS
VARIABLE RATE OF ROLL ARRANGEMENT INCLUDING CONTROLS
DOUBLE ROLL ARRANGEMENT, INCLUDING CONTROLS
PLUNGE FEED MECHANISM
STOCK DIVIDING GAUGE
ECCENTRIC SET-OVER ARRANGEMENT INCLUDING CONTROLS
RELAY-LOGIC CONTROLS (IN PLACE OF STANDARD PROGRAMMABLE
CONTROLLER)
COMPLETE ELECTRICAL EQUIPMENT FOR 3-PHASE, 50 OR 60 HZ,
380-550 VOLT INSTALLATION, INCLUDING 110VAC OR 220VAC
CONTROL CIRCUIT, TEFC-AC MOTORS (NEMA T-FRAME OR T-FRAME
MODIFIED TO IEC DIMENSIONS), DC DRIVE AND CONTROL, AND
SINGLE-SPEED CUTTER MOTOR. ELECTRICS WILL COMPLY TO JIC
OR IEC TECHNICAL SPECIFICATIONS. DOCUMENTATION TO JIC STANDARDS.
MOST NUMBERS UP TO 120 CAN ALSO BE ACCOMMODATED BUT MAY REQUIRE SPECIAL CHANGE GEARS.
THIS RADIAL SETTING CAN BE INCREASED TO 18.5” (462.50MM) FOR SOME APPLICATIONS
MAXIMUM OFFSET APPLIES TO PINION AND GEARS UP TO 25” O.D. FOR 34” DIAMETER GEARS MAXIMUM OFFSET IS 0”
