+GF+ Mikron MILL S500 – Year 2018
Travel distance X-axis: 500 mm
Travel distance Y-axis: 450 mm
Travel distance Z-axis: 360 mm
Mikron MILL S500 machining center,
serial number 107.110.00.0169 ,
year of manufacture 2018,
worked mth 41400 (incorporation) 40707 (machining) (as of 27.09.2023).
In the machine was replaced spindle after working 800mth (10.08.2018).
The machine is fully operational, serviced by the manufacturer, the last inspection 06.2023.
Based on the service contract, cyclic inspections are performed.
The operation of the machine is continuously supervised by the maintenance department.
Repair/service history for review. We issue a VAT invoice. Below is the specification:
X/Y/Z axis travel – 500/450/360mm
Working table 550x450mm
Spindle 42’000 rpm / HSK-E40 Graphite 1 piece
Tool magazine 68 × HSK-E40 1 pcs
Interface to the robot 1 pcs
External compressed air blowing 1 pc
Preparation for graphite machining 1 pc
System for graphite machining 1 pc
Laser tool probe 1 pc
Air purging of tool 1 pcs
Preparation for workpiece probe 1 pcs
Workpiece probe IRP40.01 1 pcs
APS Advanced Vibration Control 1 pc
ITC Intelligent Thermal Control 1 pc
OSS Operator Support System 1 pc
RNS Remote Notification System 1 pc
PFP Power Failure Protection 1 pc
EROWA ITS 100 holder with plate 102 pneumatic 1 pc
Handle EROWA ITS 100 with plate 118 pneumatic 1 pcs
WorkPartner 1+ + ITS 50/ITS115 MIX 1 pcs