TIMEMASTER N-2618 Engine Lathe Gap Bed
SWINGS 35″ IN GAP, 15 HP MAIN MOTOR, 240 VOLT, 3 PHASE; INCH/METRIC THREADING, 4 1/16″ SPINDLE BORE
EQUIPPED WITH 15″ 3-JAW LATHE CHUCK, TAPER ATTACHMENT, (2) STEADY RESTS. ALSO EQUIPPED WITH TWO NEWALL LINEAR SPARS, BUT NO COUNTER DISPLAY.
Swing over cross slide…18 1/8″
Swing over gap…35″
Length of gap…18″
Width of bed…15 3/4″
Spindle Bore…4 1/16″ (D1-11 Camlock Type)
15 HP, 12 Speeds (13 – 1,000 RPM’s)
240 Volt, 3 Phase
Equipped with:
Taper Attachment
15″ 3-Jaw Lathe Chuck
(2) Steady Rests
(2) Newall Linear Spars, mounted (Newall DP700 Counter Display not included)
