Cyril Bath CNC Dual Parts Extrusion Sheet Stretch Wrap Forming Machine 20 Tons – Year 2003
Used CYRIL BATH CNC HORIZONTAL STRETCH WRAP FORMING PRESS
Model V-20,
Serial Number M10307,
Mfg. 2003
SPECIFICATIONS
TWO SET OPPOSING JAWS (TWIN TENSION JAWS)
SHALLOW ARK.
SINGLE PLANE
DISTANCE BETWEEN PRIMARY JAWS:
Minimum 140″ (3,556mm)
Maximum 168″ (4,267.2mm)
DISTANCE BETWEEN SECONDARY JAWS:
Minimum 68.5″ (1,7399mm)
Maximum 92.5″ (2,349.5mm)
TENSION CYLINDER PULL:
Maximum Pull 20 Tons
Stroke 12″ (304.8mm)
ARM SWING ANGLE: Die stays constant to table.
Stretch and wrapping around die
Forward 10 Degrees Back 35 Degrees
Total 45 Degrees
SWING ARM: Extended 75⅜” (1,914,53mm)
Retracted 49-11/16″ (1,26206mm)
DIE TABLE: 3 Posts
Working Surface, Width overall 102½” (2,603.5mm)
Distance between two Front Posts centers 57½” (1,460.5mm)
Distance center of two Die Post and Rear Post Die (each side) 35″ (889mm)
MOTOR DRIVE: Wired 440 volts, 3-phase
Hydraulic Pump 100 H.P. 230/460 volts
Cooler Fan Motor 5 H.P. 230/460 volts
Oiler Cooler Fan 1½ H.P. 208 / 230 volts
CONTROLS: Window 2000 Operators Interface, QNX Machine Controls.
Power Supply. Hard Drive , 101 Keyboard. Color CRT.
REMOTE CONTROL STATION:
Power On/Off Buttons. Hydraulic On/Off Button.
Lamp Test Button. Emergency Stop and Reset Buttons.
Mode Selector Switch: Length / Manual / Auto.
Load Adjustment Dials. Right and Left Arm Back / Wrap Toggle.
Right and Left Tension Cylinder In / Out Toggle.
Left and Right Long Jaw Open / Close Switch.
Left and Right Short Jaw Open / Close Switch.
COMPLETE FACTORY SAFETY GUARDS
Overall Width 239″(6,070.6mm),
Front to Back 89⅜” (2,270.13mm), Height 76″ (1,905mm)
Weight 25,000 lbs
Approximate Total Weight 32,000 lbs.
