Description
BRYANT 1460 with 60 inch Swing Internal Grinder Machine
BRYANT 1460 INTERNAL GRINDER WITH 60″ SWING
SERIAL #: 2B15 S10210
SWING…………: 60″
STROKE………..: 16″
MAXIMUM TRAVERSE STROKE: 21″
WORK HEAD R.P.M……..: 15,25,35,50 RPM
WORK HEAD SWIVEL ADJUSTMENT: UP TO 90 DEGREES
MAXIMUM INCLUDING ANGLE WHICH CAN BE GROUND WITH FULL 60″ SWING: 60 DEGREES
WORKHEAD CAN BE ADJUSTED LENGTH WISE SO THAT MINIMUM DISTANCE FROM WORK HEAD SPINDLE FLANGE
TO FORWARD POSITION OF WHEEL SLIDE IS 21″ AND MAXIMUM DISTANCE IS 44″.
CROSS ADJUSTMENT OF WORK HEAD (FORWARD) : 16″
CROSS ADJUSTMENT OF WORK HEAD (REAR) : 14″
WHEEL HEAD CROSS TRAVEL : 8″
WORK HEAD MOTOR: ( 4-SPEED GEAR REDUCTION ) 2.5 – 7.5 HP.
GRINDING SADDLE MOTOR: 25 HP., 1750 RPM., 220/440V., 3/60
HYDRAULIC PUMP MOTOR: 2 HP.
ESTIMATED NET WEIGHT: 24,000 LBS.
EQUIPPED WITH: 60″ “T” SLOTTED FACE PLATE (3″ THICK)
48″ 6-JAW MORTON INDEPENDENT CHUCK WITH SOFT SOLID REVERSIBLE TOP JAWS
9″ THRU-HOLE IN WORK HEAD SPINDLE
INTERNAL GRINDING SPINDLE ( 16″ QUILL LENGTH WITH INSTALLED 11″ LENGTH QUILL EXTENSION TOTAL: 28″
ADJUSTABLE TRIP DOGS FOR GRINDING SPINDLE SADDLE MAN./AUTO CYCLES
SINGLE POINT (HAND TYPE) REAR ADJUSTABLE TABLE DRESSER
SEPARATE HYDRAULIC UNIT
SEPARATE ELECTRIC CONTROL PANEL
SEPARATE (BAFFLE TYPE) COOLANT TANK & PUMP.
EXTRA CHUCK JAWS (SOFT & HARD)
AUTOMATIC WAY LUBRICATION
FACTORY INSTALLED WORKHEAD CHUCK GUARD (HINGE TYPE FOR QUICK & EASY ACCESS)
CONDITION: VERY GOOD( AS PURCHASED FROM RUNNING SERVICE
NOTE: THIS MACHINE IS A VERY RARE EXTRA LARGE CAPACITY HORIZONTAL DESIGN HYDRAULIC I.D. GRINDER AND SHOWS
LOW USE ON ALL SQUARE BLOCK WAY AND WAY BEARING SURFACES.
NOTE: MACHINE WILL BE AVAILABLE FOR INSPECTION UNDER POWER AT OUR WAREHOUSE FACILITY UPON CYCLING WHICH INCLUDES REPLACING ALL FLUIDS, FILTERS, (WIPERS, SCREWS, NUTS, BEARINGS IF NEEDED) COOLANT SPLASH GUARDING, RETRACTABLE & COLLAPSIBLE TRAVELING HYDRAULIC CYLINDER GUARDS FOR WHEEL IN-FEEDS/RETRACT
