| X Axis | 750 mm |
|---|---|
| Y Axis | 500 mm |
| Z Axis | 400 mm |
| Max. workpiece length | 1050 mm |
| Max. workpiece width | 750 mm |
| Max. workpiece weight | 1500 kg |
| CNC Type | LQ |
| Worktank length | 1050 mm |
| Worktank width | 750 mm |
| Worktank height | 420 mm |
| Max. workpiece height | 400 mm |
| Automatic Wire Feeding | Yes |
| Length x width x height | 2900.0 × 2080.0 × 2290.0 |
| Weight | 5600 kg |
Sodick AQ750L wire EDM machine completely overhauled with 1 year warranty as new machines. Work performed during the review.
X and Y axis tank seal: changed Y axis shower head, stainless steel bulkheads, side seals, bulkhead sliding bearings …, final testing.
Stainless steel settling tank: Disassembly of accessories, cleaning, revision, reassembly and testing.
Front hatch: Disassembly, change of gaskets and guides for the front hatch tank complete with verification and calibration of pistons and sensors.
Filter compartment, pipes and ducts connected to disassembly, cleaning, reassembly and final testing.
Disassembly of the upper head, three-level float, piston opening, closing guide wire cleaning, reassembly and testing.
Automatic threading: complete overhaul of wear materials and calibrations from the wire tension management board, AWT motor, grooved shaft, clutch wheel, pipette .. and final testing.
Wire cutting: knife change and general overhaul.
Cleaning the inner tub, docks, ground cables, sensors, floats, bath cap and drain channels.
BS Box: Complete disassembly, cleaning and overhaul of connections, pipes and water and air pipes.
Refrigerator complete overhaul cleaning water exchanger, pipes, coolant.
Overhaul of 3 pumps. High pressure pump and 2 low pressure.
Overhaul of water management valves, deionization, filling, AWT, Low pres, High press, maintenance level …
Speed oil pump overhaul for linear motor cooling complete with control and verification of pipes and joints up to the motors themselves.
Pulse generator overhaul and calibration complete with oscillator boards and effective power in roughing and finishing.
Wire ejection unit overhaul with change of ceramic wheel bearings, venturi.
Wire chopping overhaul with bearing change, calibrated spacers and wire cutting gears.
Working contact change, lower and upper wire guide, nozle, lower head C guide ..
Control, replacement and testing of electropneumatic valves management Low presure, high pressure, AWT Jet, Drain Djust, Drain, Bs-box, Sol Q, send, Rotary ,.
Resin circuit overhaul, cylinder, water conductivity sensor, and general functionality.
Review and control of ST sensor parameters in vacuum and during machining.
Final testing ok
