Shigiya GAE-30-60 CNC Cylindrical Grinder Including Plain & Angle Head – Year 2000
Swing 300 mm
Centers 600 mm
Plain or Angle Head Angle Head
Grinding Wheel Dia. 455 mm
Plunge Yes
Gauging Yes
Dresser Yes
Control CNC (Fanuc 21iT)
Weight 8,500 lbs.
ONE USED SHIGIYA CNC 2-AXIS ANGLE HEAD GRINDER

Model: GAE 30-60
Swing over table: 300 mm (11.811”)
Distance between centers: 600 mm (23.622”)
Maximum grinding diameter: 300 mm (11.811”)
Maximum load mass between centers: 150 kg (330 lbs.)
Wheel OD, W, ID: 455 mm x 75 mm x 127 mm
Wheel peripheral speed: 33 M/sec
Wheel head angle at 30 degrees
Wired: 220v/60cy
Control voltage: 100v
Weight: 8,500 lbs.

EQUIPPED WITH:
Fanuc 21iT controls with remote pulse hand controls
Hydro Dynamic Bearings (not radial contact type)
Work head is a GU swivel type
Work head spindle stop Orientation device
Live spindle center on work head
Wheel dresser
Marposs E9 “In Process” gauging system that automatically adjusts for thermal conditions
HydraulicTail stock with #4 MT with 50mm of stroke and Fine Taper Adjustment, lever actuated
200 L coolant tank with magnetic separator
Face locator
Operators’ manual

Specifications are approximate, intended solely as a guide and are not binding. It is the buyers’ responsibility to inspect the goods and ascertain if the specifications, description, and condition of the goods conform to the buyers’ requirements.

SN: 090234 12-50, built 12/1999

Condition: Excellent with low hours and checked out by a Shigiya serviceman.

Due to the fact that this machine has been sitting idle for a number of years, the following service has been done:
New filter element for hydraulic line filter
New hydraulic filter
New pressure gauge
New pressure switch
New wheel cover open detector
New X & Z axis power & encoder servo cables