Okuma MCV-A2 – Year 2007
CNC Double Column Bridge Type Machining Center 4 Meters
Condition:used
Year:2007
Cnc control:OSP P200M
Width between columns:80”
Travel, x-axis, table:157″
Travel, y-axis, spindle head:78”
Travel, z-axis, spindle quill:18”
Dist. from spindle to table, min-max:0”—59”
Size of table, width x length:60” x 162”
Cutting federate:0.04” to 393” ipm.
Rapid traverse rate:787” ipm.
Spindle diameter:3.94”
Spindle taper:BT 50
Spindle speed range:30 to 4,000 rpm.
Quill diameter:8.27”
Tool stations:72
Tool taper:BT-50
Main motor hp.:25/30 hp. 30 minute
Manuals:Yes, complete set
Tooling:Minimal (may be more)
Machine height:17” (6’ will come off when pendant is removed)
Floor space:40’ Wide x 18’ Long
Machine weight:86,900 lbs.
The machine is under power and in GOOD TO VERY GOOD CONDITION.
It was purchased to manufacture whip stock, which is an angular down hole tool that used to be used for offset drilling.
Mud motors, directional drilling and MWD (Measure while drilling) made whipstock obsolete. It has been
kept under power in an air conditioned and heated building.
Ten years ago, new owners purchased the facility. The machine has not been used since the
new owners purchased the facility. Last year Okuma come in and powered up the machine.
The batteries were dead. They were replaced, parameters reinstalled and the machine cycled.
OKUMA BRIDGE TYPE MACHINING CENTER MCA V2
