INTOS FNGP 40 with Heidenhain TNC124 linear control
With fresh service in top condition.
This FNGP 40 has not run for 50 hours for the last 10 years.
Geometry was measured and is within the factory tolerances.
Work areas:
– X-axis 600mm
– Y-axis 400mm
– Z-axis 400mm
Clamping area of the fixed angle table 800 x 400mm
Tool holder SK40
Speed range 63 – 3150 rpm
– Stepless feed in all axes
– Hydraulic tool clamp for vertical and horizontal milling spindle

– Ball screws in all axes.
– Automatic central lubrication
– External coolant system
– Complete documentation available (Operating Manual, acceptance report, circuit diagram, TNC124 Programming Manual)
Heidenhain TNC124 Distance control
Various automatic cycles for drilling, thread cutting, bolt circle, hole lines and pocket milling.
The more modern version of the FNGJ 40
INTOS FNGP 40 – Year 2002