GLEASON 116 Hypoid Spiral Gear Hobber
| Model | 116.0 |
| Condition | Used |
| SUITABLE FOR | THE CUTTING OF HYPOID AND SPIRAL BEVEL GEARS AND PINIONS |
| GLEASON 116 Hypoid Spiral | Gear Hobbing |
| Maximum full depth | 1″ (25.4MM) |
| Cone distance, maximum | (30-DEGREE |
| Sprial angle & 12″ diameter cutter | 9″ (230MM) |
| Maximum pitch angle (shafts at 90-deg) | 84 DEGREES 18′ |
| Minimum pitch angle (shafts at 90-deg) | 5 DEGREES 42′ |
| Extreme ratio (shafts at 90-deg) | 10 TO 1 |
| Operate with “formate” gears | 2 TO 1 |
| 10 to 1 ratio | 18″ (460MM) |
| 2 to 1 ratio | 16″ (406MM) |
| 1 to 1 ratio | 12.75″ (324MM) |
| Maximum face width (depending on cutter) | 2.75″(78MM) |
| Max./min. number of teeth | 175 TO 5 |
| Work spindle taper bore dia.(large end) | 3.9″(100MM) |
| Depth of taper | 6″(150MM) |
| Diameter of hole through spindle | 3.06″(78MM) |
| Diameter of spindle nose | 5.5″(140MM) |
| Cutter diameters utilized | (150,190,230,305MM) |
| Workhead max offset above center | 4.5″ (114MM) |
| Workhead max offset below center | 4.5″ (114MM) |
| To nose of spindle | 2.5″ (63MM) |
| Cutter speeds | 20 TO 115 RPM |
| Feeds (seconds per tooth) | 9 TO 80 SECONDS |
| Feed motor | 5 HP 1800 RPM |
| Hydraulic motor | .75 HP 1800 RPM |
| Coolant motor | .5 HP 3600 RPM |
| Floor space | (1905X2896MM) |
| Machine net weight | (10,773 KGS) |
EQUIPMENT / FEATURES:
HYDRAULIC DOUBLE-ACTING CHUCKING MECHANISM
WITH DRAW-IN BAR & NUT
CAM # 43210960 (JOBBING)
LATER GENERATION HYDRAULICALLY ASSISTED BRAKE
MECHANISM FOR CLAMPING OF WORK-SPINDLE
MODIFIED ROLL WITH YOKE
CUTTER-HEIGHT GAUGE
STOCK-DIVIDING GAUGE
CUTTER TRUING GAUGE
CUTTER TRAMMING DEVICE W/HAND-WHEEL
GLEASON AUTOMATIC COUNTER AND STOP
FULL COMPLEMENT OF ELECTRICS (MOTORS/CONTROLS)
SELF CONTAINED HYDRAULIC SYSTEM
SELF CONTAINED COOLANT SYSTEM
GUARDS, COVERS
FULL SET OF CHANGE GEARS WITH TOOL & GEAR CABINET
MISC. OPERATOR’S TOOLS, SPANNERS, WRENCHES, ETC.
MODEL NO. 116 GLEASON HYPOID SPIRAL
BEVEL JOBBING GENERATOR, (ROUGHER/FINISHER),
SUITABLE FOR THE CUTTING OF HYPOID AND SPIRAL BEVEL
GEARS AND PINIONS UP TO 18″ (460MM) PITCH DIAMETER
10:1 RATIO, 9″ (228.6MM) CONE DISTANCE MAXIMUM
OF 2 DP (MODULE 12.7)
