Doosan Puma 1500SY – Year 2008
CNC Turning Center
New 2008
Swing over bed 23.6″
Swing over carriage 21.6″
Maximum bar capacity 1.75”
Maximum turning diameter, main spindle 13.0″
Distance between main & subspindle face 33.8”
MAIN SPINDLE:
Spindle speed 60 – 6,000 RPM
Spindle nose ASA-A2-5
Draw tube I.D. 1.81″
Spindle bore diameter 2.08″
AC high torque spindle motor (30 min.) 10 HP
Maximum spindle torque 99 ft-lbs
MAIN SPINDLE C-AXIS:
Minimum programmable angle (degrees) .001
Rapid traverse rate (RPM) 200
Y-AXIS:
Y-axis travel 3.94”
Y-axis rapid traverse rate 295 IPM
BED, SADDLE, & CROSS SLIDE:
X axis travel 9.8”
Z axis travel 22.8”
Angle of slant bed 30 degrees
X axis guideway span 8.9”
Equipped With:
Fanuc 18iTB Control
Chip Conveyor
Tool Setter
Parts Catcher
Main/Sub 3-Jaw Chucks
(5) MD Tool ER32 Radial Live Holders
(2) MD Double Sided Axial Live Holders ER16/ER32 (one is not working and needs bearings)
(1) Eppinger Axial Live Holder W Preci-Flex Adapter Kit
(1) Eppinger Radial Live Holder (uses same adapters)
(2) MD Tool 1” Double Tool, Double Sided OD Holder Block (2 tools on either side of turret)
(4) MD Tool Double ID 1” Holders
All original manuals, ID tool sleeves and chuck jaws pictured
Low Hours
